PCM Pin Out Chart (1992 5.2L, 5.9L V8 Dodge Ram Pickup)

  • By: Abraham Torres-Arredondo
  • Created: 22 May 2025
  • Updated: 22 May 2025
  • Articl Id: 1715
Page 1 of 2

1992 5.2L V8 Dodge Ram Pickup (Multi-Port FI)

PCM Pin Out Chart (1992 5.2L, 5.9L V8 Dodge Ram Pickup)

APPLIES TO: The 60-pin PCM connector pin-out tables apply only to:

  • 5.2L V8 (MPI) Dodge Ram 150 Pickup: 1992.
  • 5.2L V8 (MPI) Dodge Ram 250 Pickup: 1992.

CIRCUIT TEST TIPS:

1992 5.2L V8 Ram Pickup PCM 60 Pin Connector
Pin Wire Color Description
 1 DK GRN/RED MAP Sensor Signal
 2 TAN/BLK Engine Coolant Temp (ECT) Sensor
 3 RED Battery 12V
 4 BLK/LT BLU Sensor Return
 5 BLK/WHT Signal Ground
 6 VIO/WHT 5 Volt Supply
 7 ORG 8 Volt Supply
 8 Empty
 9 DK BLU IGN 12V Feed
10 ORG/WHT Overdrive
11 BLK/TAN Power Ground
12 BLK/TAN Power Ground
13 LT GRN/BRN Injector Driver #4
14 YEL/WHT Injector Driver #3
15 TAN Injector Driver #2
16 WHT/DK BLU Injector Driver #1
17 DK BLU/TAN Injector Driver #7
18 RED/YEL Injector Driver #8
19 GRY Ignition (IGN) Coil Driver
20 DK GRN Alternator (ALT) Field Driver
21 BLK/RED Intake Air Temp (IAT) Sensor Signal
22 ORG/DK BLU Throttle Position Sensor (TPS) Signal
23 Empty
24 GRY/BLK CKP Sensor Signal
25 PNK SCI Transmit (Diagnostic Link Connector)
26 Empty
27 BRN A/C Clutch Input
28 Empty
29 WHT/PNK Brake Sense
30 BRN/YEL Park/Neutral Switch
31 Empty
32 BLK/PNK Check Engine Light (CEL)
33 TAN/RED Cruise Control VAC
34 DK BLU/ORG A/C WOT Cutout Relay
35 GRY/YEL EGR Solenoid
36 Empty
37 BLK/ORG Overdrive Light Signal
38 PNK/BLK Injector Driver #5
39 GRY/RED Auto Idle Speed Motor
40 BRN/WHT Auto Idle Speed Motor
41 BLK/DK GRN O2 Sensor
42 Empty
43 Empty
44 GRY Distributor Pickup Coil Signal
45 LT GRN SCI Receive (Diagnostic Link Connector)
46 Empty
47 WHT/ORG Speed Sens Pick Up
48 BRN/RED Cruise Control SET
49 YEL/RED Cruise Control ON/OFF
50 WHT/LT GRN Cruise Control RESUME
51 DK BLU/YEL Auto Shutdown (ASD) Relay
52 PNK/BLK Purge Solenoid
53 LT GRN/RED Cruise Control VENT
54 ORG/BLK Part Throttle Unlock Solenoid
55 ORG/LT GRN O/D Lockout Solenoid
56 GRY/PNK Emission Maintenance Light
57 DK GRN/ORG Auto Shutdown (ASD) BATT
58 LT GRN/BLK Injector Driver #6
59 VIO/BLK Auto Idle Speed Motor
60 YEL/BLK Auto Idle Speed Motor

PCM Pin-Out Charts

Safety Precautions

Here are some very important safety precautions when testing the wires coming out of the 60 pin PCM connector.

  1. If one or any of the wires on your Dodge Ram pickup DO NOT match the color stated in the pin out charts, then you should not use the pin out charts in this article. Why? Because this is the clearest indication that these ARE NOT the connector pin out charts for your particular Ram pickup.
  2. Never probe the front of the connector.
    • You should use a wire piercing probe and probe the wire a few inches away from the connector.
    • You should use a Back Probe.
  3. You should never disconnect any of the PCM connectors without first disconnecting the battery negative (-) terminal.

Disclaimer

I've made every effort to double and triple check the above info (and in the next couple of pages) and I've used the best sources to compile it but nothing in life is perfect. I don't have a staff of proof readers or editors, I'm just a little guy typing this stuff up in my spare time to help and give back to the Do-It-Yourself community. So without further ado, here's my disclaimer:

© copyright Abraham Torres-Arredondo: This information is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

If you do spot errors, please let me know. You can use the contact form at the end of the article.